Ваша корзина пуста
Логин:
Пароль:
Забыли свой пароль?
Регистрация
    Регистрация
Войти через: или

HELLCAT

HELLCAT
Цена : 1.00 руб

  





Hellcat - Specifications TYPE: All valve head. Cathode bias, 2 channel with shared EQ, footswitchable reverb and channels. Solid-state rectification. OUTPUT POWER: 35 Watts POWER VALVES: 4 x EL84 PREAMP VALVES: 5 x ECC83 / 12AX7 FRONT PANEL: From left to right: 2 x inputs Hi and Lo; Modern Channel 1 Gain (higher gain channel - controls the gain / overdrive on channel 1); Vintage Channel 2 Gain (lower gain channel - controls the gain / overdrive on channel 2); Bass (Adjusts the low frequency response of the pre-amp); Middle (Adjusts frequencies around 500hz in the mid-range, which are very guitar friendly, unlike most amps you can dial in mid-range and it works); Treble (Adjusts the high frequency response of the pre-amp); Master channel 1 (Sets the output level of the modern channel 1); Master channel 2 (Sets the output level of the vintage channel 2); Reverb (Sets the reverb level for both channels); Standby and Mains. REAR PANEL: From left to right: Mains Inlet, Mains fuse, HT fuse, Speaker impedance selector 4ohm, 8ohm, 16ohm, Speaker sockets x 2, Footswitch socket, Effects loop send and return. The speaker outputs are connected in parallel. Impedances from 4-16 ohms can be accommodated and it is important to note that a resistive load or loud speaker must always be connected before switching the amp on to play. ACCESSORIES: Footswitch and top quality cable wired to Neutrik connectors; mains lead - 10 feet long (at least it'll reach the floor if you're using two cabinets), moulded plugs each end; speaker lead - 2 feet top quality 8mm cable with nickel plated Neutrik jacks. EFFECTS LOOP: Valve powered series effect loop. HARDWARE: All corners, screws, cup washers, handle fixings etc. are nickel-plated. Bespoke CNC punched, powder coated grills. 16 gauge (1.5mm) powder coated chassis with 16 gauge base / screening plate secured to chassis with 4 machine screws. Leather handle. CONSTRUCTION: Totally handbuilt and point-to-point hand wired in the UK, all components bolted directly to the chassis. TRANSFORMERS: Custom designed in house and hand wound. SPEAKER(S): Not applicable. REVERB: Valve powered footswitchable reverb. FOOTSWITCH: Two button footswitch, for Reverb and Channel switching - hand made 14 gauge, powder coated metal. CABINET: Made from 19mm birch plywood, lock jointed, finished in Cornford Oxblood Tolex. DIMENSIONS: 580 mm (W) 280 mm (H) 280 mm (D). WEIGHT: TBC

Назад в раздел

D7 Каталог 


Ваша корзина пуста